LATCHUP AND ESD ISSUES
What is Latch-up?
Phenomenon occur with CMOS/ BiCMOS circuits
Generation of a low-impedance path between the VDD supply and the Ground
Reason for Latch-up
Due to regenerative feedback between the parasitic PNP and the NPN Transistors
Impact in the design
PN Junctions can produce Parasitic Thyristor
Forms by PNP/ NPN structures
Considerable input current is necessary to activate
Thyristor formed from parasitic transistors is triggered and generates short-circuit between VDD & GND
Results in self destruction/ system failure due to the direct connection between VDD & GND
Electrostatic Discharge (ESD)
When two non-conducting materials rub together, then are separated, opposite electrostatic charges remain on both which attempt to equalize each other
A transient discharge of static charge that arises from either human handling or a machine contact
Reasons for Electrostatic Discharge
Thin & vulnerable Gate Oxide of the CMOS makes ESD protection essential for CMOS
Can be due to inductive or capacitive coupling
ESD can occur during the removal of extra metal by rubbing in metallization process
ESD occurs so rapidly that normal GND wires exhibits too much inductance to drain the charge before it can do damage
Impact on the design
ESD can also burn-out device/ interconnect if thermally initiated
PMOS is stronger than NMOS in ESD protection, because snap back holding voltage is lower for NMOS
Comments
Post a Comment